Archived posting to the Leica Users Group, 2007/01/07
[Author Prev] [Author Next] [Thread Prev] [Thread Next] [Author Index] [Topic Index] [Home] [Search]On Jan 6, 2007, at 10:42 PM, Eduardo Albesi wrote: > Hi Steve, > I had the same happen on a 24 asph not too long ago. > > There are three very small inset screws set at 120 degrees one from > the other on the front barrel that get loose over time. You'll need > a very tiny Allen wrench to tighten them. You can also use a mini > Phillips screwdriver small enough to engage the angles of the > hexagonal socket in the screw heads. thanks so much Ed... I will take a close look and will get back to you... Steve > > I hope this helps. > > Best, > > Ed > > El 06/01/2007, a las 22:08, Steve Barbour escribi?: > >> >> On Jan 6, 2007, at 5:59 PM, Frank Filippone wrote: >> >>> Steve.. my suggestion will only work for the outer ring, the one >>> that touches he rubberized surface. After that, you are not going >>> to get any results from my input. Internal rings are a totally >>> different affair, and I have no idea..... >> >> thanks Frank, for your input...the lens seems to work fine, >> nothing is loose now, and likely I will have it looked at soon by >> a local leica repair guy, or send it off if I have to... >> >> >> Steve >>> >>> Frank Filippone >>> red735i@earthlink.net >>> >>> >>> >>> thanks Frank , I will try it... though I believe the part/lens that >>> was turning is inset, and below the level of the edge...which does >>> not turn. Steve >>> >>> >>> >>> _______________________________________________ >>> Leica Users Group. >>> See http://leica-users.org/mailman/listinfo/lug for more information >> >> >> _______________________________________________ >> Leica Users Group. >> See http://leica-users.org/mailman/listinfo/lug for more information >> > > > > _______________________________________________ > Leica Users Group. > See http://leica-users.org/mailman/listinfo/lug for more information