Archived posting to the Leica Users Group, 2007/09/29
[Author Prev] [Author Next] [Thread Prev] [Thread Next] [Author Index] [Topic Index] [Home] [Search]According to George, over at Quality Light Metric Co.,7095 Hollywood Blvd., (323)467-2265, the solder points are notoriously prone to corrosion. When you take the case off, don't be too surprised by all the built up gunk everywhere. s.d. On Sep 29, 2007, at 3:15 AM, Vick Ko wrote: > Fantastic, I can fix solder. > > regards > Vick > > -----Original Message----- > From: lug-bounces+vick.ko=sympatico.ca@leica-users.org > [mailto:lug-bounces+vick.ko=sympatico.ca@leica-users.org] On Behalf > Of Jerry > Lehrer > Sent: Friday, September 28, 2007 10:37 PM > To: Leica Users Group > Subject: Re: [Leica] MR4 died - what are the typical failure modes? > > Vic, > > The cell is usually long lived. Most failures are usually due to > loose > ontacts > > > Vick Ko wrote: >> I brought out my MR4 meter tonight, popped in a good battery, and no >> response to light. >> >> Were these prone to dying? What was prone to dying, the photocell? >> >> Frankly, I can't remember if it worked when I put it away, over a >> year > ago. >> >> Vick >> >> --------------------------------------------------------------------- >> --- >> >> >> > > > _______________________________________________ > Leica Users Group. > See http://leica-users.org/mailman/listinfo/lug for more information > > > _______________________________________________ > Leica Users Group. > See http://leica-users.org/mailman/listinfo/lug for more information